zesty
07-28-2007, 06:30 AM
The IC-F2010 receive and transmit frequencies can be edited in the dealer set mode directly from the radio front panel.Press the [PO] and channel up button both in together and power on with the blue power button.
'DEALER' is indicated.Next enter the six digit dealer passcode via the programmable assign keys.In the software the dealer default can be re-edited.After the six digit code is enabled 'SET MODE' appears on radio screen.
Push the [PO] or [P1] and 'SET MODE' will be omitted.Now the Icom commercial transceiver is in the "Dealer Set Mode" region.A channel number will appear.When the [P3] is pressed this channel digit will blink.Use the channel up or down buttons to select a channel you desire to edit.
When a selection is chosen just push [P3] again to stop the number blinking.Begin at the channel digit and scroll down with the down channel key.There will be the letter R at extreme left of display.This is the receive only frequency edit section.
Seven digits of the frequency can be edited.Push your [P3] key to begin editing.The first receive number will blink.While this digit flashes push the channel up or down key to select a number.Now press [P3] to enter this digit.Henceforth the number will be entered automatically.
Use your [P3] button to continue the editing.Now the next digit will blink.While it blinks press channel up or down to choose a digit.Press [P3] and the chosen number is entered automatically.Continue your previous editing procedures.
When the three digits or zeros are flashing together this is the last increment for direct entry edit.Use the aforementioned editing procedures for the final step or increment.Push the down arrow key to scroll along for your transmit editing section.
This transmit editing region will be designated with the letter ' T ' at extreme left of radio screen.The same operational procedure can be used for direct entry edit of transmit frequencies.If the IC-F2010 does not accept a frequency the display text or the channel number will blink.
Also its possible that the transmit icon will be absent or it will flicker as an indication of non acceptance.The receive and transmit frequencies can also be inhibited in dealer set mode.
'DEALER' is indicated.Next enter the six digit dealer passcode via the programmable assign keys.In the software the dealer default can be re-edited.After the six digit code is enabled 'SET MODE' appears on radio screen.
Push the [PO] or [P1] and 'SET MODE' will be omitted.Now the Icom commercial transceiver is in the "Dealer Set Mode" region.A channel number will appear.When the [P3] is pressed this channel digit will blink.Use the channel up or down buttons to select a channel you desire to edit.
When a selection is chosen just push [P3] again to stop the number blinking.Begin at the channel digit and scroll down with the down channel key.There will be the letter R at extreme left of display.This is the receive only frequency edit section.
Seven digits of the frequency can be edited.Push your [P3] key to begin editing.The first receive number will blink.While this digit flashes push the channel up or down key to select a number.Now press [P3] to enter this digit.Henceforth the number will be entered automatically.
Use your [P3] button to continue the editing.Now the next digit will blink.While it blinks press channel up or down to choose a digit.Press [P3] and the chosen number is entered automatically.Continue your previous editing procedures.
When the three digits or zeros are flashing together this is the last increment for direct entry edit.Use the aforementioned editing procedures for the final step or increment.Push the down arrow key to scroll along for your transmit editing section.
This transmit editing region will be designated with the letter ' T ' at extreme left of radio screen.The same operational procedure can be used for direct entry edit of transmit frequencies.If the IC-F2010 does not accept a frequency the display text or the channel number will blink.
Also its possible that the transmit icon will be absent or it will flicker as an indication of non acceptance.The receive and transmit frequencies can also be inhibited in dealer set mode.