zesty
08-05-2007, 10:03 PM
The selcall receive code channel numbers can be enabled or cancelled within your radio dealer set mode.These receive code digits can also be set up or omitted in the CS-F1000 Rev 1.2 clone application.In the clone software if it is enabled the indication is 12345678.If you omit the digits the application will represent it as a continued line as in '_______________'.
Enter your dealer mode.Begin at the channel number and navigate the menu with channel down button.After the indication of 'LOG _ _ _' there might be an appearance of 12345678 or a row of eight underscore dashes as in ' _ _ _ _ _ _ _ _'.If the numbers appear this means that the receive codes have been enabled.In the event that only eight dashes are shown this means that the receive code digits have been cancelled.
Whatever is shown in dealer mode will relate to what has been edited in the cloning application.Please allow me to submit an example.Have scrolled the menu and after' LOG _ _ _' there is an indication of ' _ _ _ _ _ _ _ _' My F2010 has programmable assign keys on the front panel.
To enable the receive codes of 12345678 i push the [P3] key and then my [P2] key to enter the numbers.Basically you first press [P3] and then your second procedure is the [P2].To put it in a nutshell an actual key sequence must be adhered to.Henceforth your key sequence is [P3] [P2] and it has to be in that order.
I have chosen to cancel or disable the receive code digits.To activate this function i will use exactly the same key sequence for the enabling of codes.This is done by pushing [P3] [P2].To cancel it i press [P3] key and the receive code number will blink.Now i push the [P2] key and the number is omitted from the radio screen.This key procedure is continued until all the digits have been replaced with dashes.
This section is the final adjustment area for the dealer set mode channel menu.There are other parameters that can be adjusted from the F2010 dealer mode.I will continue with postings when ever time permits me to do so.
Enter your dealer mode.Begin at the channel number and navigate the menu with channel down button.After the indication of 'LOG _ _ _' there might be an appearance of 12345678 or a row of eight underscore dashes as in ' _ _ _ _ _ _ _ _'.If the numbers appear this means that the receive codes have been enabled.In the event that only eight dashes are shown this means that the receive code digits have been cancelled.
Whatever is shown in dealer mode will relate to what has been edited in the cloning application.Please allow me to submit an example.Have scrolled the menu and after' LOG _ _ _' there is an indication of ' _ _ _ _ _ _ _ _' My F2010 has programmable assign keys on the front panel.
To enable the receive codes of 12345678 i push the [P3] key and then my [P2] key to enter the numbers.Basically you first press [P3] and then your second procedure is the [P2].To put it in a nutshell an actual key sequence must be adhered to.Henceforth your key sequence is [P3] [P2] and it has to be in that order.
I have chosen to cancel or disable the receive code digits.To activate this function i will use exactly the same key sequence for the enabling of codes.This is done by pushing [P3] [P2].To cancel it i press [P3] key and the receive code number will blink.Now i push the [P2] key and the number is omitted from the radio screen.This key procedure is continued until all the digits have been replaced with dashes.
This section is the final adjustment area for the dealer set mode channel menu.There are other parameters that can be adjusted from the F2010 dealer mode.I will continue with postings when ever time permits me to do so.