ChrisS
09-06-2006, 09:42 PM
Hello,
Was wondering if anyone would happen to know whether it was possible to upgrade the onboard Firmware on a Series 1 T2015 to enable it to be programmed via the Windows based Software ?
The Radio is running V2.05 presently but when connected to the Windows program it responds with " Cannot Program with 16 Chan and 16 Tx with this version " or similar.
The radio enters programming mode but when the computer tries to read the radio's database the above message appears.
Alternatively if anyone happens to know which Version of the DOS software would most likely match up with the V2.05 onboard Firmware the radio has at present i would be grateful for any info.
All replies gratefully received,
Regards,
Chris S.
Was wondering if anyone would happen to know whether it was possible to upgrade the onboard Firmware on a Series 1 T2015 to enable it to be programmed via the Windows based Software ?
The Radio is running V2.05 presently but when connected to the Windows program it responds with " Cannot Program with 16 Chan and 16 Tx with this version " or similar.
The radio enters programming mode but when the computer tries to read the radio's database the above message appears.
Alternatively if anyone happens to know which Version of the DOS software would most likely match up with the V2.05 onboard Firmware the radio has at present i would be grateful for any info.
All replies gratefully received,
Regards,
Chris S.